Green J1939 9pin Female to OBD2 Female Cable

General Discussion
#1

Hello, I want to connect the AutoPi Telematics unit to a truck that has the green J1939 connector, will it work if I use an ODB2 to green J1939 cable ? Thanks

Like this one

#2

I can read from the documentation at J1939 Getting Started Guide | AutoPi Documentation

The AutoPi device must be Connected to the vehicle with an appropiate OBD-II adapter cable that connects the vehicles two J1939 CAN bus wires to pin 6 (high) and 14 (low) of the OBD-II connector on the AutoPi device

I take that it should work if it only requires the LOW and HIGH wires to be correctly connected to the ODB-II plug, any confirmation from experienced people in the AutoPi would be appreciated. :v:

#3

This topic was automatically closed 33 days after the last reply. New replies are no longer allowed.