Subject of the issue
In the category “Trips” is only shown the start- and endpoint (I wanted to test the dongle and drived threw the neighboorhood), but not the route which was driven.
Your environment
2019.05.08, totally new dongle, got it two days before
Steps to reproduce
Drive to any destination, wait till the dongle uploaded everything and then look up in Trips, what route you was driven.
Expected behaviour
You should see, what route you choosed and drived.
Actual behaviour
I saw only start-/endpoint (it was the same) and no route I drived.
Output of power.status command
rpi:
uptime:
days: 0
seconds: 193
since_iso: '2019-06-22T18:01:29.163651'
since_t: 1561226489
time: '0:3'
users: 1
spm:
last_state:
down: none
up: 'on'
last_trigger:
down: none
up: spm
port_a: ‘10100111’
port_b: ‘00000111’
sleep_interval: 0
version: 1.1.1.0
stn:
battery:
level: 100
state: charging
voltage: 14.6
last_trigger:
sleep: NONE
wake: NONE
trigger_config:
ext_wake: ' HIGH FOR 2000 ms'
uart_sleep: ' 900 s'
uart_wake: ' 0-30000 us'
vchg_wake: ' +0.20V IN 1000 ms'
vl_sleep: ' <12.20V FOR 240 s'
(The dongle shutdown due to no electricity, while I write this…This is what the dongle shows after restarting the engine)